Elevator Forum

Ya, just use your FAST tool.

You talk to the door board with a FAST tool or equivalent as if it were a DMC. The interface between the controller and door board is all discrete.

Sounds like it thinks it’s a 2 stop

What type of FAST tool are you using?

Do they read to ground?

Does PSC or NSC read to ground?Have you tried to plug in from the door board or selector in case the plug in the COP is bad?Check the Transorbs from P...

Do you have a TKE parts catalog?

Like I said, the old software will not work in your new BP4 CLC. You either need to find a good BP2 or earlier or order DK13 software.

I’m not sure about that RER but older software didn’t support the valid floors parameters yet so probably nothing wrong there. There are basically 2 t...

I’ve done 1, took 2 days, works great. Make sure you order the tensioning bracket for the motor. I ended up mounting deep strut to the car top and usi...

What labeling is lost?

Are you sure this is a traction elevator? It sounds to me like it’s a roped hydro that is leaking down and re-leveling.

If RRF does not clear the run monitor, what are the faults?

Sorry, ya got me.

The board in the picture says Conquest