Elevator Forum

I can confirm that the AAR1 board communicates with the PA door boards over CAN with or without a controller. I have a door simulator with a PA6 board...

You do have to bump it down off the limit for it to write the working values of the floor counts. But if you uploaded the parameters, why do you have ...

Ya, a PA board is all that’s inside an HD-LM or a Smartech II. PA6 for 1/6hp DC motor and PA7 for 1/2hp AC. But those are just what’s typical. Either ...

I didn’t say it was a good idea…Other options would be a 6300ABN3 the update to the old Smartech used on TAC-50. Than would require a separate box.You...

It’s an SPI loop so you need 2 CAT 5 cablesFor 24 or 48 vdc inputs 6300TX1For 110 vac 6300TX2For 240 vdc 6300TX3Then you’ll need a 6300HL1 UIT for adj...

Is that in the US?

They need an expansion board to be fully discreet

I’ve had trouble in the past trying to help someone on a DMC with the World tool. I’ve never used it and it doesn’t translate will with the original F...

Do you know who made the fixtures? How about the controller? The ACE isn’t going to help much because it has nothing to do with the way the key is cut...

In general, with an intermittent fuse blowing, the best approach is to split up all branches of the circuit with in-line fuses to narrow it down to 1 ...

No, you need the selector

Is there a CE electronics PI driver board? Unplug it, it fails often. If not, read DC volts from CAN high to ground and CAN low to ground. You should ...

That’s the only thing I can think of that would cause the car not to take a 5th floor car call or hall call, assuming CLC Adjustment 2 is set to 5. Go...

It looks like this: Attachments Fujitec Wizard.png (183.63 KB, 63 downloads) Last edited by Indirtwetrust; 05/01/21 04:00 PM.

Right, it is a different Wizard program. The regular Wizard will not work. Maybe you can buy it directly from Fujitec.