Elevator Forum

You do have safe right? C LED is lit. They will say NAV with safe open. Like if the stop switch gets flipped on the IOBD.And not sure if the car would...

Do you have the Fujitec specific Wizard program? It should say Fujitec on the main menu screen.

So even while the riser is down a DHNF shows all HNs online? While it’s failed measure the voltage on the CAN channel before and after the repeater. F...

Is there a repeater in the controller for the hall riser? There should be for a duplex. Make sure the termination resistance is correct, should have 6...

Make sure CLC Adjustments 53 & 57 are set to 1. That is for a front 5th floor opening.

From the master car, type DHNF for front, DHNR for rear. There will be a 1 or a 0 next to each node. If that node has a 0 you probably need to replace...

Those have been tried too

Those have been tried

I’ll also take possible login & password combinations for a site computer

That one doesn’t work

This should make more sense:Car/Group IO Alignment

Alternatively, lay out your group IO map on top of the car’s and line it up so the FSE FSX FSM columns are right on top of each other. Post a pic and ...

Ya you need better IMS

Ya, just right click on the IO, click add or change an IO, delete the IO name. You won’t see the changes until you write it, reset the CPU, and reload...

See my edited post