Elevator Forum

Is FSC2 high in the car?And can you see the IOs change state in the group IO map? Also make sure there aren’t any other FSH IOs anywhere in the group....

Usually if you can’t get the doors to open after a hoistway scan it’s because the floor validation parameters are not set correctly. Check CLC adj. 52...

The LON cfg file is just a text file. If you download the LON cfg now it should have everything but MAINCOP1. You can use the IO map to fill in the bl...

Are you using a null modem adapter?

You should be able to just disconnect GPSC and GNSC at one of the controllers. If this is car 2 maybe it defaulted back to car 1.

They show up in the LCE error log. Under E-1. Last edited by Indirtwetrust; 03/31/21 07:40 PM.

No learn on a 330A

Apparently no, Zap can no longer get IBM relays.

I would really dig in on that generator wiring since it had gone out for repair. Some Otis gens are extra complicated and it helps to have the end dia...

Do you have an HHT?

Thank you!!

Try setting CSW bit 14. In Remote Fast enter: BITS0,14

So you have each floors up & down buttons jumped to the car calls like a 1 button collective? I guess that works as long as you have a relay drop ...