Elevator Forum

Construction, the first two years. Maintenance till 2015.I pretty much agree with all of above. This business is not what it used to be any more, back...

PM me, I have some.

I like Coast PX25, one button on/off, never liked those H/L thing, high is good. But low is just useless too low. sometimes a simple headlamp is a goo...

if elevator runs fine 95% of the time, this is going to be a tough situation, since you can't fix it if you don't see the problem, could be chasing gh...

FCTRB represent number of floor controller link1 communication errors, you might have floor controller board issue. Try Status-Car-Srv and Status-Fc-C...

1. Check the Service Status Message in STATUS Mode, not from ACTIVE ERR.2. How about T69 and B69 signals.3. If unit S/D after door open on 1st floor, ...

E311 was right. might have CS stuck in, or FT malfunction.

SP=Car Stopping Pilot. if I remember it properly, should be in with either UC, DC or CC. then self holding through it's own contact.

Check the aux. contact on MS contactor, It has something to do with that awful UMD issue.

Recently Retired. had one rope hydro issue similar to this one. every once in a while, cables are out of the sheave trigged the slack cable sw. shutdo...

Located in the back of control, you'll find contactor #14 and #15(depends on vintage), make sure they're O.K. if not. you'll have leveling issue.

could it be Virginia Control?

I didn't know MCE has this program, will try to get in touch with them. Thanks.

Thank You Guyswhat I was trying to do is emulate exact the M/R monitor, it's easier for me to troubleshoot the system all by just myself, because some...

procomm plus is a terminal program, i'm using it to emulate m/r monitor by plug laptop into mc-pa board.