Elevator Forum

you could switch to MCE and have the same amount of problems you have now and waste a bunch of money. is it controller problems, door problems, or do ...

i think we should just go lock out every car with an expired permit and see how the public would react. bet a buck a lot of people would want the elev...

with the constant pcf's i would now lean towards the ppt. i can tell ya that a new ppt is a $1000 and hopefully its the newer style or else you have t...

not sure of the part number. are you talking about the escalator round plug Diag. Tool?

some imperial ac motors were wound to otis spec/labeling. if hooked up incorrectly like it was a nema spec the fields fight each other and create high...

its a easy upgrade to maxton. keep it a down leveling unit, pick both up coils off of an aux M contact. better yet install a soft starter with it and ...

Most shackle manufactures spec springs to take some of the shock load and they also help keep proper tension if you have twisting cables. I don't see ...

the problem with a lot of restrictors, especially GAL, they can be forced open by most people or get stuck in the open position. the older units that ...

It would be worth it to upgrade the board to a lrs5 and have the branch do the programming. It should have been done 20 yrs ago.

That's not a normal fault, I would swap out the processor.

i agree that there should be a forum in cyberspace where we can all come together and discuss the topics of our trade. i disagree that it should only ...

I forgot to mention that the local oil distributor in this small town actually called us about this guy because he couldn't understand why the guy nee...

how old is this elevator? is the motor in the oil? in ground cylinder or above ground? my guess is that you have air in the system and its bouncing at...

i went to a non contract customer in a small hotel, he wanted us to figure out why his elevator wasn't running. come to find out the owner had been ad...

The better question is where did all the oil go?