Elevator Forum

ITI comes to mind. I think I remember a job they had made s silencer for. Other than that, what about a second muffler? Or go look at a 330A and see w...

Your DET and UET sensors are latching. Could be a failing sensor. I would immediately order and replace the cigar sensors, could be the problem, eithe...

Kings 3 has the whole getup. I'd start with them. They're pretty top notch equipment and do the monitoring too if you need. They also have the cellula...

Sounds like something failed in the leveling circuit. Are your inputs on for Level up/down and door zone? The car will level with doors open

Dirt is right. You can always try putting it in phase 2 to cut out the light curtain to rule it out

Thats a good trick Montana. I have had good luck cleaning them before if the screens dirty and car won't level by removing and hitting it with a can o...

Measure how far out the adjustment is now. Take the two bolts holding its plate to the valve body. Pull the whole thing out, replace o ring.

I thought only the v3f16l had a tach, kdl and kdm have encoders?

They come in smaller containers like 3 or 4 inches by 10 inches. Might be easier to keep in your truck or carry in. Does nitrogen compress back into l...

Very smart way to do that. I bet one of them paintball gun co2 cylinders could work too

Is this motor compound wound? If it is, are the series and shunt fields hooked up cumulative or differential? Whats the armature voltage compared to n...

Sounds like your motor shunt fields might be too weak. That would explain the higher speed and armature current. If your shunt fields weakened it does...

I haven't put one on myself, but I have seen an ecospace with an oiler on the ropes, wick type

First thing you need to do is pop the battery out of the CLC card, with power on. It's a BR2430. It should be over 3.0 vdc. If it's less than that rep...

I second the PSI recommendation. I've used laptops from them before and they do what they're supposed to