Elevator Forum

HiAre you putting it for any reason or are you just wanting to access the menu, as the last post says just plug it in and you have access.Dave

Hi,Did you check to see if board is charging the battery?

Hi,No it can't, you can get them erased ready to go on next lift if you know how, where are you based?Dave

Unbelievable!

Hi, Does this happen with a empty car or with load?

Hi AndreaCheck email.Dave

Yep they are cheap enough, I take it they are formula system?Dave

Could also be a bit of protective film on doors, don't think I've ever seen a Kone lift with it all removed especially monos, I've had same fault &...

Yes you must do a shaft setup.Dave

Hi,You could try clean the tacho, that's the 108, if you've not done it before, ask for instructions, what machine & drive is on it?Dave

Hi, The braking resistor gets controlled on one of the internal transistors of the igbt, this fault gets thrown up nearly every time they go, I'm afra...

Hi, they are a problem to repair, depends what you think you've done to repair it, no doubt you changed the igbt module, but it usually takes some oth...

Lol, I completely agree, Kone know they are a bad drive, that's why we have KDL now, & I can't understand how they can get the guides so wrong eve...

Hi sumanlift,21 is a safety fault, f3 is just fault No 3, what is f1 & f2 fault & is this the only problem you have, 21 fault will also appear...

Hello again,Sometimes helps to do the shaft setup by giving the car a start with a very short stab of the brake release, but you'll prob find it will ...