Elevator Forum

As for the button replacement that solid state started this thread for, it should be easy if it's just the one button, put the lift on RDF & switc...

Hi mate,I think there's a few reasons why, one of them might be the contactors inside, if they are going HR that might be putting too much strain on t...

Hi Eric, how did you manage to do that? I'm nearly done with another two drives will keep you informed how they go then I'll get the info to you, I th...

Lol it's a good trickDave

PM sent

Sent you a PM

I don't follow you, you can't access faults unless it throws a fault up? What is it you are trying to find, if you go into E on the menu that's where ...

What drive have you got? The drive doesn't have a display it uses the CPU display if you are not used to it, I wouldn't touch it, 0026 is usually the ...

Any one interested in parts CPUs, ADOs options boards, rectifier boards,V3F 25, V3F16ES all used, from a refurb, but in working order, I have other pa...

Have you got a price in mind?Dave

Are you still wanting these parts & where are you based?Dave

All you have to do is put the N/O contact on a third party door edge system between pins 46 (GND) & 44 (PC1 IN) on plug X15 on AMD1 Door board, it...

Hi,They should just be formula systems edges, very cheap if your in the states I don't know where you'll get them & you don't have to buy from K1,...

Are you sure you've got a KNX & not a VOI it wouldn't be the first time someone made that mistake and a costly one at that, it will say on the fro...