Elevator Forum

Are you able to access the menus or are they locked out?

If it’s not the input from safe edge it maybe a faulty D/O button, it’s stating that they’re open device is triggered?

Hi, have you got anymore faults logged ?

Check safe edges bud 48 is reopen device probably why your doors are staying open??

Ahh right I take it you’re in the USA no worries hope ya sort it Dave

It could well be your brake check function on the KDL16L I’ve had the same problem, the KDL checks the brake pods individually, and if one is not hold...

Paul Clark very nice fella very helpful 👍

Hi,That is your optos it looks like they knew what they was doing, I've repaired quite a few of these boards and yes the optos have been a problem, bu...

Hi, you could try Servicing the Tacho, brushes out, take the back off, careful not to lose the thrust washer at the back, blow dust out, don't inhale,...

Hi, You could try monitoring the output voltage from the brake unit to the pods under load, around 200vdc if I'm correct? The brake units do fail, but...

Absolutely agree with koneisland fit a memcom or any less hassle

I tend to agree with John Jay, try reverse motor leads!

Hi,Did you replace the board with the same version, was it G01 G02, was the problem on before you changed it if so why did you change it? Dave