Elevator Forum

I had this issue up in Scotland about a year ago, luckily it was a duplex so I copied the NVram from the other drive on my pc, did the setup drive and...

Ok, no problem 👍

Hi,I have the D01 if that’s any good to you?

That’s a crapper mate, I’d be looking at cpu next? I know it’s a lot of messing about but what else is there? You seem to have exhausted everything el...

It’s worth a try bud, tbf I think it was one of the 61 proxy’s that I had problems with, 🤔

Car top board Yep that’s the one,

Hi,Could be the CCB board, I have had one of these intermittently not responding to the pencil switch inputs? Might be worth a try?

Glad you got it sorted, Thanks for the update Jo 👍

That’s a brake control relay from a V3F16es The KDL16s brake board is inside the drive

0126 (3075) is your Brake control Board, more than likely the Relays, they can be changed separately, I’ve done quite a few, it’s a pain to do on the ...

Check parameter 1 - 95 it should be set to 1 this sometimes defaults to 0 I’ve had this a few times? Don’t forget to cycle the power when you change a...

I’ve got the very same one it’s great

Typical, the Dallas ones fine and Farnell show ST one not in either I keep quite few spares, and definitely copy the chips if you can, I always do, go...

Hi, you should be able to replace the old TI chip with the ST one M48Z128Y-70PM1Is the other one losing its parameters? Think they usually guarantee t...