Elevator Forum

Fault 0169 ( KCM 83...
 
Notifications
Clear all

Fault 0169 ( KCM 831 )

10 Posts
6 Users
0 Reactions
31.7 K Views
(@frankyboy)
Trusted Member
Joined: 17 years ago
Posts: 29
Topic starter   [#9899]
Got this fault that keep coming back 0169 , I check the voltage coming from the batterie , I have 13volts , I reset it but it the fault come back again ? any suggestion ?
Thx



   
Quote
(@john-jay)
Prominent Member
Joined: 17 years ago
Posts: 798
 
the battery should be connected to the ccbn board at XB32. The LCE runs a battery test every 24 hours. You should have a battery ok light on the car top ccbn board. you could have a bad connection if the battery is charged.



   
ReplyQuote
(@frankyboy)
Trusted Member
Joined: 17 years ago
Posts: 29

   
ReplyQuote
(@kiwinightstalker)
Estimable Member
Joined: 17 years ago
Posts: 145

   
ReplyQuote
(@frankyboy)
Trusted Member
Joined: 17 years ago
Posts: 29
Topic starter  
Ok I install a new batterie and everything is back to normal , I dont understand the old batterie is still giving me 13.5volts ?Anyway thanks



   
ReplyQuote
(@kiwinightstalker)
Estimable Member
Joined: 17 years ago
Posts: 145

   
ReplyQuote
(@dmhughes)
Trusted Member
Joined: 17 years ago
Posts: 81

   
ReplyQuote
(@john-jay)
Prominent Member
Joined: 17 years ago
Posts: 798
 
when you test voltage and suspect a problem, it is a good practice to use an analog type meter such as a simpson. they will put a load on the voltage and give you a truer reading. a digital meter will often give you a false voltage. they are a wonderful tool, but not fool proof. when testing a higher voltage such as 120 volts or higher, a wiggington or wiggy is the truest test.



   
ReplyQuote
(@aus-bob)
Active Member
Joined: 17 years ago
Posts: 3
 
Yes 0169 fault the car top connection board does a load test on the battery , so even if the battery reads ok by a meter it could still fail , there is also a small resistor pot at the top of the board if you adjust this you increase the charging voltage to the battery , in sydney we find these pots are set to low .



   
ReplyQuote
(@koneisland)
Trusted Member
Joined: 17 years ago
Posts: 93
 
Originally Posted By: frankyboy
Got this fault that keep coming back 0169 , I check the voltage coming from the batterie , I have 13volts , I reset it but it the fault come back again ? any suggestion ?
Thx

If your lift was still operational while flagging up a 0169 fault then you better check all the relevent parameters as they must be on the wrong settings. 0169 fault should kill landing calls to prevent passengers entering a lift car which has a bad back-up battery.



   
ReplyQuote
Share:
Scroll to Top