Elevator Forum

It's barely lateral but I think you're correct lol

Is the up relay picking ? And also do you have voltage at the valve coil? Is it an mph1 or mph2?

Is it an LRV 3 ? Cuz it might need the cap in the cop to be bleed off to reset the processor

I have an eye bolt that fits in the top of the first section that I used to lift. I also didn't need to pump any oil out cuz I evacuated the entire oi...

Don't rush. Take your time. I had to hang the car in the overhead and come out through the escape hatch. Then do the whole thing off a ladder with my ...

I just found we have a job with one of these old dover rotary units (1957) and one of the more seasoned guys in our company said it's an early GAL pro...

Most importantly, what clutch are you running. That will determine what you can replace that with that's a common part

Not sure about the SL but the brick will work on an HS. I just had to do a floor table on one.

I tried emailing you some stuff last night but for whatever reason it doesn't look like my emails are sending .. change Mcss param "INVERT WCC/MUS" to...

You have to go in and change a couple parameters, and also move a couple suitcase jumpers. I'll email you a write up I made tonight

Or even worse get yourself or someone else very hurt

Alt floor is there too I just saw it and also MR FS action for flashing hat options for smoke heads... After re-reading what you post I'm guessing thi...

Im guessing if you dig around alt floor is there somewhere

I have not done this but if you have an android phone or tablet you can down load "Miprom 21 quick reference" app. It is a picture of the brick as an ...