Elevator Forum

What kind of security? on a GeN2 TCBC/GECB controller you can program it to lock a selected floor and open it with a 3 digit pin code using the car ca...

Maybe a bad encoder/vane sensor? I would try a new learn trip first, before I change the encoder/vane sensor...../AlexError ID: 1501 Message ID: 05DD ...

B-04 NAV DPController B - On the 4 stop - Not AVailable - DDP (Running Time Exceeded).Look in Drive if it is a traction elevator... But like Rolly sai...

Get to the site with a service tool...Look in the LCB-II PCB in menu M-1-1-1 what shows in top line of the service tool?After that look in the OVF Dri...

When the GECB displays "Shutdown" it is related to a Drive fault.What software is the Drive running? From the fault it could be an Ultradrive AP131400...

Faulty 1LV / 2LV / LVC relays... Replace all of them.../Alex

you can get from www.elevatorcommerce.com in spain. /Alex

JNFF = Switch Firefighter Service (NC) (For the fireman to start Fire Service mode)Is it FW Switch in TKE for Fire Service....?

drop me a pm with you email...

LZS = Located on the SMIC HMI Module / SEM Module (Depending on Bionic version) in the controller cabinet. The LED shows that the supervision system f...

From the manual.....*6 Vane Count Error (Non Blocking)This failure appears when the lift stops out the stop Vane due to incorrect counting or slipping...

You have to define the "Floor Map table" for landing doors with normal- / heavy doors.On the SMLCD go to:- Login -> Parameters -> Door -> Lan...

Thank you, Yus123It is much appricated!

Did you enter the correct values from the old drive? and preform a new learnrun and loadweigh calibration?I would look at some specific parameters to ...