Elevator Forum

Schindler 5500 door...
 
Notifications
Clear all

Schindler 5500 door drive programming

9 Posts
4 Users
0 Reactions
9,704 Views
(@heisenberg)
Reputable Member
Joined: 17 years ago
Posts: 280
Topic starter   [#27569]
Anyone know anything about programming the dde-v35 door drives on a schindler 5500?

Does It need to be programmed with the hand tool? Can be programmed through cadi?



   
Quote
(@alex75)
Estimable Member
Joined: 17 years ago
Posts: 130

   
ReplyQuote
(@heisenberg)
Reputable Member
Joined: 17 years ago
Posts: 280

   
ReplyQuote
(@sampler)
Estimable Member
Joined: 17 years ago
Posts: 89
 
you can only programme speed rate and learning with keypad that is on the door. all parameters inside the controller. you can adjust via menu.

Last edited by sampler; 08/17/19 07:53 PM.


   
ReplyQuote
(@meprom21)
Active Member
Joined: 17 years ago
Posts: 8
 
Does anyone have any manuals on the 5500 they would like to share or trade for? I do have a variety of other manuals/prints i could help with. Thanks



   
ReplyQuote
(@heisenberg)
Reputable Member
Joined: 17 years ago
Posts: 280

   
ReplyQuote
(@sampler)
Estimable Member
Joined: 17 years ago
Posts: 89

   
ReplyQuote
(@alex75)
Estimable Member
Joined: 17 years ago
Posts: 130
 
You have to define the "Floor Map table" for landing doors with normal- / heavy doors.

On the SMLCD go to:

- Login -> Parameters -> Door -> LanDoorWeight

For each floor level:
- Enter physical floor numer:
- Floor = 1 -> OK

- Set door weight to:
- Normal Door or Heavy Door.

/Alex



   
ReplyQuote
(@heisenberg)
Reputable Member
Joined: 17 years ago
Posts: 280

   
ReplyQuote
Share:
Scroll to Top