Elevator Forum

You cant use a generic Vacon drive, the software is not the same!Also if you upload the TKE software to a generic drive, you would need an activation ...

You did set the correct motor type in the parameters? And the encoder in the end of the motor is tight with the motor shaft? (There is an allen bolt t...

I assume that the drive runs software xxx31400xxx?Did you use the eeprom from the old drive or did you enter all the parameters in the new drive with ...

What kind control board does the 211 come fitted with? Also the software version would be helpful (most likely printed on one of the eproms)./Alex

The com settings for a SCIC Q3.1 board shoud be as below....Baud Rate 9600 Data Bit 8Parity NoneStop Bit 1Flow Control OFFAny hyperterminal should be ...

What version of the SCIC pcb do you have? Some the earlier ones had a different com setting then the later ones....

Open Loop or Closed Loop?/Alex

Problem is with the AC voltage supply, the voltage threshold is 80% of the actual rectified AC line voltage.Have you measured the AC line supply volta...

pm on the way.....

Dont think it can be done, KONE always put this software version in, when they the loose a unit.Just update the software to a higher version, then use...

What kind of autodailer do you have on the unit? Schindler TAM/TAM2 ect.? and what protocol would you like use? P100?

Well, 10 series did have a few bugs in them... Do you want to update the software? If you do, send me a pm.../Alex

What software version does it run on now?

One could suspect the LVPB power supply to have lost it? Did you replace the board?/Alex