Elevator Forum

Had the same kind of issue on an LCB-II, had to replace the LCB-II pcb at that time.... So you could have a similar problem here?/Alex

Send me a pm with your email if you want the manual for this.../Alex

Error ID: 3620 Message ID: 2414 NameShort COM_DRV_NOD_D NameLong E_COM_DRIVE_NODE_DEAD ErrorGroup 3600_3699_COMMUNICATION SourceID Description The com...

Does the LV1 and LV2 become "low" when the car leaves the bottom floor (and 1LS) ? (Check them in the input menu).If one of them stay "high" when off ...

Safety circuit fault, but more likely faulty resistors on the AS029 Mainboard, look for burnt resistors on the top left side of the board./Alex

@Stall ProtectionYou have noted that we discuss the new "KCE" controller, not the "KCM-831" controller?If you have any info about the "KCE" and Hyper ...

Well, is that not the same as being locked?Unless you have the app, mini console or KCE maintenance tool, you cant really do much on these controllers...

Adjust the SPD_KP parameter, also did you measured the weight of the counterweight and car? You have some parameters where you can enter these values....

Or a replacement V1 core to solve the issue..../Alex

I found something in an old baseline release document....2014-05-23 GAA30782GAAFirst baseline for GECB Computing Core V2 (AxA26800AVPx) Not compatible...

Just wondering, if you have an OMU module.....Could one backup the software from the V1 board and update the V2 board with that software? (never tried...

The ABA26800AVP1 looks like it just the computering core (V2 means more ram, faster cpu ect.) I suspect the old V1 core runs software xxx30780xxx? and...

Drop me a PM with your email!

92: The monitoring of I/O's in Travel Control detects abnormal status of I/O's of inspection panel circuit for REC or RH panel. The malfunction can be...

212: Door can not open due to repeated activation of KOKB (Door opening force limiter)Check the door lock ect./Alex