Elevator Forum

Swich off both OCB and RPS breaker, then the battery should not be flat when powered back on.

Go to menu 10 - EnterSubmenu 127 - EnterChange the 0 to 1 and hit enter.UCM fault should be cleared now!/Alex

From the fault code is sounds like the Drive is gone...Have you tried a menu 10 - 101 reset?/Alex

Replace contactors SF/SF1 on the drive unit, then you should be all good to go!/Alex

Menu 10110 = Car Call111 = Hall Call/Alex

What kind of drive?

02 41 19 93 R High Wind OperationHigh Wind Operation signal fromthe Building Sway Detector (BSD)unit is active.LCEOPTG11, F front, input3 for NA, LCEO...

If it is status code 40 you are asking about? That would most likely be a defective SIM card (or missing) in the controller...The configuration data i...

Depending on the age of the GeN2 and what kind of drive used.... OVF Drive -> ALWcomp Corr (Correction factor for internally calculated loadweighin...

Maybe a bad input on the SMIC PCB?

-000_ _ _ _"-" No direction of the car."000" Shows the speed of the car."_ _ _ _" No safety circuit at all, if the safety circuit was good, it would s...

Drop me a pm with your email. Last edited by Alex75; 11/29/20 04:58 PM.

The modutool is a good tool, but it looks like the development of the tool is not keeping up with the new controllers on the market now....

I am pretty sure it is a GCS, the software is a bit different from the euro version... in the US version section 7 is security. (euro 9).Let me look t...

What kind of GeN2 is this? US? do you know what control board is used in the installation? (software version would be even better)/Alex