Notifications
Clear all
Topic starter
08/06/2022 4:21 pm
Anyone know of a unlocker tool that will unlock a Kone lce with 6.7.18 version software?
I've tried a relatively cheap unlocker tool and Modutool, both unsuccessful.
08/06/2022 10:31 pm
Dont think it can be done, KONE always put this software version in, when they the loose a unit.
Just update the software to a higher version, then use the LCEUIO or Modutool to unlock the interface.
Just update the software to a higher version, then use the LCEUIO or Modutool to unlock the interface.
/Alex
Topic starter
09/06/2022 8:58 am
Can you help me through the process of updating the software?
Topic starter
09/06/2022 9:40 am
Or can the KNX board unlock parameters?
09/06/2022 10:37 pm
pm on the way.....
16/04/2023 6:12 pm
Please kone unlock lce parametro cpu..thanks
21/04/2023 4:03 pm
if the drive still has the nvram, not the soldered memory, it will suffice to fill it with FF and put it back, but you will need to re-enter the install parameters. This process can be tedious if it is a device with special characteristics, if it is a standard device with a single entrance and without keys, all you have to do is read the hole to recognize the floors and address the remote stations (floor plates )