Elevator Forum

If you put in a motor that has a varistor temperature sensor, when the control is wired for bi-metallic, (or visa-versa), you will have problems. Chan...

Did you ask your boss?

Check all your grounds?I know it's not much, just throwing it out there. Last edited by Vic; 03/29/12 11:32 PM.

Yeah, Scott, I think you're right about the DOL probably not being "it", because there's no door time. I was thinking that too, but you gotta start so...

That's something I would really want to watch in the m/r, while it's happening. I would watch the state of DOL during the open cycle, for that ends th...

What's the motor waveform look like on a scope?(When the problem is occuring) Last edited by Vic; 03/26/12 11:50 PM.

8^)

Are you saying "does anybody know what clad cut means", other than, the cutting of a circuit trace? Are you asking what the electrical signifigance of...

2.Where do you work? Outside North America? Last edited by Vic; 03/20/12 12:10 AM.

Unitec couldn't help?

I've never seen one, but It's measuring the electrical continuity of the belts, right? Sort of like a big ohmmeter? So couldn't you lift one of it's m...

Time to push for mod. It's only been 90 years!Seriously tho, good luck with your search.

I think the guys who could answer that are long gone...

Founding member of the "6850" Fan Club!J/k!