Elevator Forum

there is usually a resistor/diode around the brake coil, have you tried decreasing the resistance? if so, i have had a few over the years, that do thi...

Rolly is absolutely correct, I have seen this many times in the last 30 years also, Unforturnately the mechanic will sometimes increase the voltage to...

when you are doing the setup, while watching the screen, it usually says floor 1 ok, or good, floor 2 ok, etc. was this being displayed on the screen?...

I'm with cucuvator, pixel is fine, but the h900 will give you a big headache. Tech support is ok. the hydro product is ok. In my opinion, there are to...

strange, postal i was able to invoke the system confidence test, using hyper terminal,then it asked for the password. the test came up ok so you can d...

i did not, but i sure will thanks

update, i got my hands on a different cpu, installed it, and same problem. So i did the self confidence test, and the dsp, and pmi boards were no go, ...

the laptop fast tool, is a very good tool, just as good as the handheld fast, if not better. What makes you think it is the tool? can you communicate ...

give me a call in the morning, what happened, did you get it to run today? I thought it would not run, are you now back to it overspeeding but at leas...

thanks for the info rolly, well all went well, I had to reprogram 7 of the 10 floors, with the top floor being a little over an inch low. This was my ...

Hi Rolly, I just purchased a Dataman unit. Played around with it tonight, going to give it a go in the morning. I have a couples pages of info, but it...

q can u pm me also thanks

thanks for the info, its an older tac50 with 6300JC3 CPU board. vertical express had them for 1395. We are waiting on customer, they may want to just ...