Elevator Forum

Overhead is definitely the way to go!

Well I can definitely agree that if there was any possible way for TKE to accomplish this, then they definitely would. The IMS version floating around...

I've not heard of this, and I would be skeptical to believe it. What about Owners IMS and Machine Room monitor? If this were true then how would those...

That is "Stall Protection" basically Low Oil or Pump Time whatever you prefer to call it . I have replaced these before with octal base plug in timer....

http://the original host/forums/ubbthreads.php?ubb=showflat&Number=1054#Post1054

If you jump out contacts on voltage monitor does issue persist? I think the orange ones are problematic, you could possibly rap on the side of it with...

Did this get resolved?

I know this is a long shot, but is the MG set spinning the right direction? Was it doing this before you blew it out? Did you go back with the same br...

There was a bulletin about adding suppressors when you had Car Light and Fan Shutdown relay, CLFS. They would be located behind main swing panel , on ...

If overshooting both directions, is CLC pulling in at the end of run?

With all the boards replaced, it sounds like electrical noise. Just to clarify the coil suppressors that TKE uses has a resistor in series with heat s...

TKE has dual sided motor pulley. Larger radius side is less torque more speed. Maybe use this side and then greatly reduce all door speeds, but you mi...

I double checked!731AG12 - Non Regen Accord 60hp VVVF is obsolete because of non available Semikron power cube. This will be replaced by 10k drive.

I know there is software dependent on which processor board is on front of the drive MCINV5ST, or MCINV6ST; then two different versions of each of the...

In my opinion it is very likely that door stroke is not set properly. I see this all the time, stroke not set right, guys try to use electronic adjust...