Elevator Forum

I believe NO APP means there is no application software loaded on the CPU. You need a Kone Flash SD card with the latest version of software to make t...

Sorry, late to the conversation but it was likely the BAT-RAM chips on the MLB.

I’ve gotten IFBK fault from having close manual speed to high. I never set above 60. Open and Close Manual speeds get adjusted too high when people wa...

Indirt has it correct. Just use W-R once you made it to top directional to stop ring. Be careful using the W-R test points because it jumps everything...

Torque limit is indicator of bad motor encoder

I actually think that there isn't a book for the G40. Maybe they didn't produce enough of them to warrant making a manual

Don't worry about SP and NP, those will start functioning when you get CWIL online. May have to reconfigure again since you tried that once when CWIL ...

I worked for a small company that was purchased by Otis. Eventually Otis lost most contracts, and all the employees that came with the independent the...

I have been hearing about more instances of Otis equipment losing eeprom . On 211 it's the chip that holds parameters, U26. If you rule out normal ele...

TKE will sell IMS to customer. Make sure they ask for Machine Room Monitor version, not Owners IMS. If it has the LCD display with four buttons mounte...

I have 73-A2S7900H

Also spring underneath car need to be stretched to 20 in approximately so cable has proper tension

It may be a bad RIF board. Also keep in mind that problems like these arise if customers switch to VOIP over traditional analog phones line. Only KONE...

I agree with jumping out voltage monitor especially if it is one of the orange ones. Possibly this is emergency stop from CPU shutting off very briefl...

If you have AH or AN software you need CLC that is 6300BP1,2,or 3 or old blue board. If You have 6300BP4 you need software upgrade to 675DK## . What v...