Elevator Forum

So the terminal back up scan is on the job cofig thumb drive? I am curious about that. Not trying to play devils advocate....but if you had to use the...

The cn card replacement took care of the 1021 fault. Thanks for that. We got the shaft set up and the car runs. We are going to come back with the Acc...

Anybody know the outcome of this?We have one now that is down and our tool will not communicate also. We went to another one that we have and our tool...

We were getting this fault code often . Oddly enough group of three and it was car number two. Ours would drop the calls and passengers would think th...

Might have to try that, with the magnets on like they are supposed to be, it will not take a learn run and when it gets to the top, it gives a 693 fau...

On the set up for this magnet installation, it states that on most two landing jobs you will not be able to install more than the six count tbs magnet...

Yes Last edited by solidstate; 12/07/17 11:52 PM.

Could be it was doing this before the magnets.

sending you what I got

google push button flip guards and there will be many choices

We have had this issue also, we started getting our packings from gorman and it made a big difference. Gorman is visibly beefier and has held up so fa...

I do not think we have ever used the FLTN Rolly, will have to remember that one.

I think we can close this one out. When we got the 963 faults yesterday, we checked the encoder and everything seemed good.We tried another DSP board ...