Elevator Forum

Is it concord?

Never heard of a Conquest. Where are they out of?

pm email address

Sad to say...We never found a definite problem with this one. Our motor would run, high speed valve would not come on. We were not getting voltage bet...

I do not BELIEVE that this is your issue with the tool. We had to use the original brick tool that Montgomery had a few months back on one. We modded ...

Probably same thing, as this starts on page 7 also. I will send it to you if you want.

The only thing I have other than prints is the BHMC-15 Adjustment Procedures. It might help out.

pm or post email, i will send you what I have.

Closing this one out. Bad capacitor below the fuse block 4600mf

post or pm email

Close this one out. E Brake not picking fully. Odd that it would only fault out at the top floor. Thanks for the help.

Must have had one beer too many last night. It is a 663 Fault not a 683 Fault

That odd, IMS is saying excessive torque fault