Elevator Forum

Construction guys get it from knowledgable general contractors too. If I had a dime for every time a GC asked me when his door frames were going to be...

IMS helps, no idea about pre programming but it's worth a shot. Not sure how the DMC Dovers were set up as I was just a wee apprentice back then, and ...

I also would think its the relays, as a manual reset clears the issue for "days or weeks". Missing magnets would normally be picked up on the very nex...

Ok peep, I will be on an inspection tomorrow that should allow me time for a precise write up, or if you like, private message me with a phone number ...

Never put water back into the pvc. You will never know if the pvc has sprung a leak. I always landed my jack to keep it down, plumbed it up, then back...

Typically the generic UDC software is set up for AC center opening. Might have just gotten lucky vatorgator and it matched. You will need to get softw...

Even worse TMD, I have worked on elevators that almost seemed giddy at the opportunity to take a finger, a foot, a life. Some designs, usually due to ...

Yeah the list does go on, from building support, brackets, rails, ropes, shackles, car frame itself...and that's just the bones to make it go. Now the...

BRG probably more likely with the explosion in media, we are hearing a lot more about places we never would have before. A lot of the fatal accidents ...

Hahahaha, oops, time for a mod? Let me know how the owner takes that, I may use it. Last ancient POS I was at, I found myself casually daydreaming abo...

Or make the in swinging door, into an out swinging door? Just change the door jamb and door, cheap, easy, done.

Standard is a loose term. Standard for me on a leaky repack is to first run the car with the bad seals still in place checking for damaged pistons and...

Don't forget blood type JKH, and if they employ gingers....we all know gingers have no souls....

Sanding sleeves are installed at the head of the jack, and as the elevator runs, it mildly sands the piston down. This is used to remove nicks, dings ...