Elevator Forum

checked the manual, it says if the clc board has 5.0 to 5.1 volts, and the watchdog LED is not on, then either the board is bad, or the software is no...

hey smitty, that was one of the first thing i had him check, the 24 volt power supply in the controller. he says all is fine, i will check the toc 24 ...

The mechanic has been recording info with the wizard monitor. this is where he sees all of the I/O on a few of the SMI boards go off. will check it ou...

Make sure you have 5 vdc at the D4 diode, cathode side. if you have less then five volts here maybe you have a bad connection at lcc11. the d4 diode i...

slip ring motor. Just popped into my head, not sure why. I must have seen it once before. If I am right do i get a star :}

I say its a old imperial.

great, wonder why they would add such a timer.

focus on troubleshooting the car dropping direction while on inspection, it is a fairly simple circuit from that aspect. things to check out, pushing ...

here is the latest regarding this accident

Well, It has been a couple of weeks since the new ppt was installed. I have registered no more PCF or Vmode5 errors while checking the 40 test. before...

Im with you on the board, that is probably not the problem, but you never can tell. are you sure the tape guides are not sloppy? when you say the Swit...

Thanks Guys, interesting, I did not know CEC was owned by TK. I had some literature of the quantum drive that was on a TIV. now i can get it all. I sa...