Elevator Forum

First I seriously doubt all boards are NEW. Repaired is more likely. You may have inherited someone's problem in a repaired board especially if it run...

In addition to these errors below check the pico fuses on the DSP board. Tac-50 is the multibus system and uses 99.9% of T4 Errors.102 T4 ONLY. Loss o...

What do you need? The TMS 600 software is made from the 200 data base. Not a whole lot more in common. I/O Board is the only common one I can think of...

Access Electronics in MD does a great job repairing almost any T-III board. Even the old obsolete CPU Boards. Phone there is: 301-645-1733. They shoul...

21 UCLS is a geared unit with a 6850DK Selector(No Advancer Panel). To run on Inspection you need DX-HX which picks D and H. If the relays are picking...

Without looking at the old commands I have in notes somewhere, do remember you must have a db9 or db25 pin null modem connected to serial cable. There...

Solid Slate!!! Latest stuff!!!

What version of IMS was this outfit selling? was it 16 bit or 32 bit? 16 bit is 2.3.X.X 32 bit is 2.4.X.X and later!!

Get the controller data tag info with the wiring diagram number. I may have prints for it!

Also check the Power Supply to the Encoder for "ripple". Grounding and shielding could also cause those problems.

PM me your info. Have all of that. The drive is the same as a 900/9000 SCD. The only difference between the 700/900 is the 700 has no data concentrato...

Not sure what a 1624 Selector is but have Adjusted many 2 SP AC's with 6850 Selectors and Odd/Even Floor Vanes. The basic slowdown rule on any of the ...

Check your IMS Version Number. Think the number is under one of the sub-menus under Help. 2.3.x.x is 16 bit. 2.4.x.x and later is 32 bit.

Try these guys and see if they have a kit or package:

 Beginning of door close 00 89 Lock check relay Faulty relay, F7 fuse blown LCR is activated CD_INFO should be ON, LD_INFO should be OFF