Elevator Forum

Here is an example of addresses of one software version. I think if I remember each hex digit is 1/32". If this is not your version I have some older ...

Do you have an EPROM Programmer/Eraser, and able to edit the files created on a chip read?

I suggest before pot tweaking make sure the loop circuit is free of grounds or at least 1 meg or more above ground. If grounds exist in rigging, armat...

What country are you in and what Drive is with the TMS 600? If your in USA the Drive is KONE SCD.

Contact Luke at "Access Electronics 301-645-1733. They repair the older CPU Boards. Does an excellent job.

PM me an email address!!

The TMS 600 Motor Field Board uses the K1 relay for the detection of Motor Field. The Brake Board is the same board without the use of the K1 Relay. T...

Does the pump motor come to an abrupt stop at the floor? It has to run to bypass the fluid to make the soft stop? Just looked at prints on those old o...

Just be sure someone did not move the top of car switch to make it stop level with the hard stop. I have adjusted over 100 of those type hydros and wa...

Does the Elevator stop short of the floor when it stops hard? If so and this is an Otis Hydro, there is Condenser Timing around the Dump Valve (Leveli...

PM me your email, send you what I have.

Think I answered that before in this post!!!

Pretty sure the 8 is a job specific of the C1S/F6834A. Could be an additional non-standard key switch installed or some special feature. Most of the t...

Message me your e-mail. Have a pdf file for MPH II with the APE option. It is 7.6 megs & 50 pages in size so make sure e-mail will hold that much.

This is exactly what happens to a Kone MX machine when their crappy brakes fail with no cwt safties, rope gripper, and no 214 relay to limit speed to ...