Elevator Forum

You can simulate TOC inspection from the controllers 1064 board if necessary.If you are not an elevator mechanic please call your elevator company. Mo...

PM sent.

I know you said you changed the hall button interface...Was that on both cars?I had a similar problem a while back on an LRS3 duplex. I changed the in...

I have replaced a few of them. As everyone stated it is a 2 man job and it is a Formula Systems Edge. I think its the only product Kone Spares does no...

Thanks for the reply. A hoistway learn corrected and hasn't come back in since 5/2.

The company I work for installs majority GAL. Once you work on the product it is easy to approach. Getting good tech support from GAL can be tough. Fr...

I'm very curious. Is that the actual job name for the jpg?That looks like the SCR drive portion of a TMS700/900 control.I ask because I have been on a...

We have 1 unit and have had the same experience as ABE.

I've been told Component Source was taking over parts. Not sure about tech support though. I've always liked working with Swift products. Hope their s...

Larry,Message me your email address. I will send you a guide I have.

Thanks for the info Scott. I was unaware of that procedure on duplex's.

I've always turned the power off just on the car I am working on. When I change the power board I pull all the other cards out of their sockets. I ins...

I worked on a Pegasus lift a while back that needed a new board. No one had it. Everyone said parts are hard to find. The lift was installed about the...

Yes. Scrape the cap off and replace the resistor above the diodes. You can either solder another cap across the diodes or just leave it off. I haven't...