Elevator Forum

Take a look at the inertia setting in the drive parameters , if set too low it will cause undershoot and it will crawl into the floor . Too high and i...

Forgot to say if in M-2-1-2 it says D in bottom right then load weighing is disabled .

first check the ocss log M-1-2-2-1 you will have some 1700 faults if its going NAV look what other faults you are getting around the same time , to ch...

Great explanation ! Thanks silly ...

Thanks JKH will pm you.

Also if you cant access the car top but you know have the overhead and the counterweight is sat on the buffer you can put jacks under the buffer to li...

Somebody sent me a great write up for the valve block and some installation write ups for the DMC 1 but could still do with some more troubleshooting ...

I adjusted down high speed on the only one I worked on up to now with the minimum of info ( someone told me adjust it only depressurized) for a cat 1 ...

Thanks beupeep , I will take a look

Will do jluff.

I've had Gen 2 do all sort of wacky stuff , switching fire service of and on lighting up every button and like you firing the earthquake board . If th...

I don't have a write up as such but know the tests ( at least the ones we do ) . Off the top of my head and early so if anything wrong please feel fre...

Vatorgator is right , straight forward swap out usually.it sounds like you have the older 211 with the piggy back board ? Just swap the base board , i...

Do you have a service tool ?