Elevator Forum

Otis stuck in overh...
 
Notifications
Clear all

Otis stuck in overhead with finals picked

8 Posts
7 Users
0 Reactions
9,794 Views
(@bigshow79)
Active Member
Joined: 17 years ago
Posts: 5

   
Quote
(@rolly)
Honorable Member
Joined: 17 years ago
Posts: 729

   
ReplyQuote
 jkh
(@jkh)
Prominent Member
Joined: 17 years ago
Posts: 904
 
You would be the first to find a car on safety in the overhead. Is this a simplex? You will need access to the car top. Hopefully you will have enough room to lift the car to release the safeties.

Last edited by jkh; 02/18/17 01:06 PM.


   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759

   
ReplyQuote
 jkh
(@jkh)
Prominent Member
Joined: 17 years ago
Posts: 904

   
ReplyQuote
(@newmech)
Estimable Member
Joined: 17 years ago
Posts: 203

   
ReplyQuote
(@uppo72)
Honorable Member
Joined: 17 years ago
Posts: 562
 
Originally Posted By: jkh
When you used your jumpers, the car wouldn't run down or it slipped traction and wouldn't move down?

Yep the OP isn't specific enough. If the car can run, and there is enough room to lift and the CWT isn't landed you should be able to get the gear out. If not the car may have to be lifted via block and tackle, even from thru the rope hole in the MR floor, which I have seen before. If the car is slipping then the fitters can even use the traction sheave to lift the car via soft slings.



   
ReplyQuote
(@pieman)
Estimable Member
Joined: 17 years ago
Posts: 103
 
Also if you cant access the car top but you know have the overhead and the counterweight is sat on the buffer you can put jacks under the buffer to lift it and remove buffer which may give you the room you need to release the gear . .



   
ReplyQuote
Share:
Scroll to Top