Elevator Forum

Hi John jay, tanks higher than piston heads so no low pressure. In the Uk we don't really use buckets. There are two large drip trays that the piston ...

Just an update, did a rupture valve test and now have a leak from one set of pistons . Is this the original problem ? Don't know , bit at least it's s...

Wondered that myself..pressurised it dropped it back on props , left it , repressurised it ....nothing . Not a drop. It's one that has you questioning...

Hey IDWT , The oil was In the pit . It's a well sealed pit with no sump and I had to have it sucked out by oil removal specialists. When I arrived the...

As someone who made the simple mistake of fitting a ka1 where shouldnof used a Ka2, trust me it WILL damage the processor. Also you cant buy them anym...

The fact you are getting both TCI lock and TCI ON message randomly could be a trailer fault, find some spares and change out the return wires from the...

As people have said its an I motion, do a learn run on it but make sure your belt tension does not allow it to slip when reaches fully open or closed ...

What type of operator ?

Its not unknown for companies to take on contracts with equipment they can't look after and then immediately recommend refurbishment but it sounds tha...

Glad to hear he is going well . a lot of the people I did my apprenticeship with back then are no longer with us unfortunately .

The above is a link to a company started by a guy I used to work with on H and C ( rip ) many years ago , I haven't seen Paul for twenty years or even...

You gotta hate jobs like that . if you open up the swing panel with MLB on it you will see two LED's B and BE on the terminal rack , these indicate th...

Its in the brake / dbr parameters in the drive set up ,module 4_3_1_3 Brk sw pres Change to 0 Jump out brake switches in controller . You should only ...

Brake switch monitoring is in the drive parameters, I believe it will say 'brake switch present? ' and the options are 0 and 1 . If you say there are ...