Elevator Forum

I'm with you both on just ordering a new pushbutton, but unfortunately my supervisor believes it's an addressing issue. Is there a method of programmi...

I have a monarch with no paperwork/prints- 3 stop traction.Any chance you could help?

I'm always using this one:

Nope, won't allow me to login with it. even tried to slowly and firmly press the buttons...nothing unfortunately.

noted, I'll meter through and see if that may be the case. I appreciate everyone's help!

Check the first 2 terminals on the left (pc & sc) on the power card - should be 5vdc.Also check pc to 24d - should be about 25vdc; if not you coul...

Hmm, I have a generic set of prints I could send you - I don't know if it will be any different than yours.Unfortunately, I haven't had any experience...

Do you have a set of prints for the job?

I'm having an issue logging into one TAC32 I just picked up. i believe someone has changed the password to log in - the generic password does not work...

I'll give a shot at reversing the leads and see what happens.uppo: It is a DC supply. I have a picture of the board if a visual look at it helps - I n...

I have the correct voltage from D1 plug to the board but I did notice from GNDext to +24ext I read 32VDC.I get a signal for close & open as well a...