Elevator Forum

This is my unit info Attachments 20230331_114319.jpg (2.11 MB, 30 downloads) 20230331_120810.jpg (2.4 MB, 19 downloads)

Sounds like motor torque is too high, I would check your brakes to start with

Not sure if this has been corrected. If turning your inspection keyswitch to on then back to normal doesn't work then, Assuming you have a blue tool, ...

If prints are available for this, I'm in desperate need for a set as well

JIEFENGELEVATOR, is this the manual for the black or blue tool? I have a black tool I'm trying to troubleshoot a unit with right now and have no manua...

Philly: touche hahaJohn: Common & dispatcher are considered the same, correct? I suppose the main concern at this point is if these signals are lo...

Put it at the top landingturn controller to inspectionlogin on the SMLCD and go to "acceptance test" or "hydro test" - i can't remember which onerun t...

Yes, i read from both side of where that fuse is with and without fuse in. Left side OL right side 1.5kOhm. A couple of other guys said it sounds like...

They ended up buying the switch. Like you said upanddown, it wasn't very hard just extremely tedious. Luckily i was given paper work to follow through...

Will do.Thanks again for all the help!

Menu 5Sub menu 7Value 1 (or 2 for older models i believe)The cpu will scroll through numbers..Cycle power once the cpu reaches 5 7 1 (or 5 7 2)Honestl...

I just put in a new push button, and found it was a blank. I tried the 5 second hold and didn't work. Tried 10, 15 seconds and nope. I think i just ne...