Elevator Forum

Try C5 as the feed C6 is gate c7 is doors, all with respect to HLI if you're checking it with a meter. The feed may vary but try to put voltage (110vd...

**Make sure the door op is NOT on TEST. This will cause the same problem. Won't run and no errors. Double check that and I'd even ohm it out, check it...

Any decent Mechanic who can read a print should be able to figure that out.

Take a look at the GAL GALaxy controls. They're very nice. EC is pretty good, if you get a traction, pixel is the way to go. Good luck.

I'd disable the security and see if it still happens. It's odd that it only happens on the secured floors.

I've worked on both in mods and in service. Hands down the Galaxy's are better. Easier to work on, software upgrades can be emailed to you and are qui...

When you de the ascending car test, assuming the car is completely secured, you'll need to manually hold open the brake and let the gripper stop the c...

you should just be able to turn the speed up with your tool, under msu adjust. I'll double check my book when I can, but it should be pretty simple. W...

I've used both, and if you have the extra money, get the Kone service tool. The world tool has some bugs, I've had problems with accessing certain par...

you'll need to check the parameter to the second landing and make sure it's set to read out 2.parameter 3_2_2 (for second landing ) should read someth...

yes, 1_45 0= off 1= car calls 2= hall calls 3= both. But thats only if you're using option boards, more than likely you are. Also, make sure all the s...

On a KCM Hydro if you want lower it on the springs to do work you need to hold in the buffer test switch, then when you run it up push in the button a...