Elevator Forum

Check the drive sheave the first one I ever put in was cut too deep from the factory and had to be replaced,ran fine for a while then started slipping...

Probably not,and it depends how they r wired the only way to find out is to try it

Sounds like the safeties are grabbing too tight,have u tried adjusting the safeties?

I'm sure u checked but they have been known to lose the rubber ring on the wheel,diameter set to 37.5mm?

A couple I have were Cavetating and had to add a bucket of oil,they create a vortex and once in a while would growl at the top floor.

Were u getting do and dc at floors that's where I d start.had a solid state doing that and found bad R1 in doors and that fixed the see-saw

Their number is 1 800 873 8731 for dynapar,could try Adams cause they use these on Schindler mods. If it's the flex coupling u have to be extremely ca...

What kind is it a dynapar ?

Try yanking the xm16 plug to reset the CPU as far as going into fire service I gotta think about that one?

Some tac20s bring up the 33,55,57 when the hook is pulled the others are doors turned off and door wd and losing CPU memory what else got wet?

U have to make your own prints for this thing,the mechanic before me drew up a print on the one I looked at like I said not much to these and yes it's...

Should be a stop switch in car to check also,double check the limit at the top,not much to those up and Down contators I'd say the lock at the top flo...

State light shouldn't be orange,u have to do the learn till it goes off sometimes it takes multiple attempts as for Lon failure try doing a Lon downlo...

Try doing a learn trip on your doors,is your state light on or off?

Appleton Wisconsin