Elevator Forum

Software and yes the manual

Sounds like a dumb reply but r there any Aux contacts from the hook to trace?

I work 4 tke and we can't get nothing for these,was told by my office to make a list of all lmh's for sales guy

I think you can turn it to L-50 just to get it running for time being

Make sure all your drive parameters are set,Lon download for the new boards,tac voltage set menu 6-10 -3.610vdc,set resolver angle,adon learn next,may...

Did u learn the resolved angle

U could try swapping those gateways boards for different results and the fcbs,the faults say ur not seeing 2,3,4 floors,do u have rear entrances?chang...

Well did u throw any boards at this thing?

1402-lce can't see 2nd floor fcb 1403-3rd the 2402s are rear side and so on ,shaft setup must!!! Have doors and hall calls inhibited on cpu

Try swapping the gateway board on the bad one to a different car to see what happens,and the shaft setup the car needs to be just a fuzz above the bot...

Go back and check all adjustments especially 62-69

Sounds like the serial number for the job from factory

Yes it is but ims is easier to use

If memory serves those faults sound like no comm to floor controller boards and each fault will tell u which one isn't seen,the board on the CPU is th...

I had this problem and changed the brake module board to fix it,could also check ur tach and encoder any little movement will bring up the fault