Elevator Forum

TKE Tac 20-03 door ...
 
Notifications
Clear all

TKE Tac 20-03 door not opening

8 Posts
6 Users
0 Reactions
12.4 K Views
(@detroit-city)
Eminent Member
Joined: 17 years ago
Posts: 25
Topic starter   [#17210]
I have a Tac 20-03 and no service tool. the elevator is a two stop, front opening only, the basement flooded and moisture was in hoist way. Elevator will run but it stops opening the doors. The car answers calls but no door open. mainline the controller and it resumes normal operation for about an hour. I have the following faults repeating themselves in the log, 1014,1057,1083,1006,1103,1033,1055, and 1041. another interesting thing is sometimes it says fervice 41 instead of service. Any suggestions as to where I should start?



   
Quote
(@lowoil)
Reputable Member
Joined: 17 years ago
Posts: 270
 
Some tac20s bring up the 33,55,57 when the hook is pulled the others are doors turned off and door wd and losing CPU memory what else got wet?



   
ReplyQuote
(@take-the-stairs)
Estimable Member
Joined: 17 years ago
Posts: 120
 
You lost all your memory you have to start from scratch. All your saved parameters are gone. Days work if you don't have the setup saved for this job. If If you do reload, and do a selector learn run, set fire Svc, if faults still happen you have software damage. Call tke, and get out your cheak book.



   
ReplyQuote
(@whadafack)
Trusted Member
Joined: 17 years ago
Posts: 80

   
ReplyQuote
(@detroit-city)
Eminent Member
Joined: 17 years ago
Posts: 25
Topic starter  
To Lowoil. nothing got wet directly. the customer told me water pipe broke, the entire basement had several inches of water, pit flooded, humidity in hoist way and in cab. nothing looks water damaged, it just doesn't run correct. is there a service tool out there for purchase?



   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759

   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759
 
The 1014 and 1083 are telling. You need IMS and probably software. Interesting though that it runs for a while. Make sure your power supply is like 25.5 volts and the battery on the CPU isn't shorted or something but not sure if the 03 had a battery? Probably.



   
ReplyQuote
(@gs264)
Trusted Member
Joined: 17 years ago
Posts: 52
 
We have a 20-03 doing a similar thing. 1033,1055,1057, 1041 and 1086 faults. Car intermittently will not leave first floor and throws those faults. We have checked and changed magnets, replace both selector boards checked wiring. Doors close, car goes no where, doors reopen a few minutes later and goes back in service running fine for days. Any ideas?



   
ReplyQuote
Share:
Scroll to Top