Elevator Forum

Like I said before move the cigars closer together with that 118 6010 fault, I've adjusted dozens of cheapo spaces and that fault comes up when runnin...

I think you need to move them closer together a little then repeat set up

Check the sub code,6010 is min.overlap is 10mm,6011 max.overlap 20mm.you need to spread the cigar switches closer together or further apart.

I still have the micro sd card and write up but getting it to you is another story

When I worked at know they sent out a article for a fault that was occurring with leveling,the service mechanic order a new oscillator thinking that w...

Bad rail job car could be moving away from magnets,3/8" from magnet to cigar switch

Is it weed?

O29

Either gates or doors,look on the print and see what brings in t4 led.

I'll testify to that connector, we finally found a screw terminal plug for that one,one too many callbacks

What's your p17 and p18?did you check slow down magnets on the back of the tape

Replace the floor controller board for that floor,had a car that would be on phase 1 every morning.replaced Fcb and option board and problem went away

Do u have at least 24v funny things can happen if too low

Check 1a and ta

Same fault low oil or bad level up eye