Elevator Forum

Make sure final limit setting at bottom floor is at least 80mm from ramp when lift is level at bottom floor then carry out a shaft learn.If you don't ...

Basically just slows and stops lift in a controlled manner during an emergency or power cut etc. Avoids the passengers being subjected to the discomfo...

The diodes in these edges can deteriorate with age so if alignment and cables etc are ok you may have to renew the edges Last edited by koneisland;...

Originally Posted By: Elev^te79 Does anyone have a complete set of fault codes for schindler 3300 MRL ? PM me please. I can e-mail some info to you.

Originally Posted By: Elev^te79 There's about 6 sub codes. When your 108 fault appears press select and it will give you a sub code to your 108 fault ...

Don't recall 0108 having a sub code.

Make sure tacho is 100% and shaft learn completes 100% (0118)Also check pencils and that magnet polarities are all set correctly (stripe visable). Don...

0103 fault is Braking Resistor damaged. 0026 is just letting you know that the drive has reported a fault.

Car light supply goes through ADO boards on Monospace MkI models.I have had to replace a few myself after accidently grounding live parts when trying ...

AC supplies for car lights/fan go through ADO boards which remains live even when lift is switched off. I would check out lights fans etc before fitti...

Once was on a job installing lifts in new build high rise buildings where all the lift cars were dropped into the hoistways fully assembled before the...

I hear that Kone are now experiencing problems with their new KDL drives both KDL16 and KDL 32.

I don't buy the dry guide theory as I have replaced loads of drives which have all worked trouble-free after replacement without lubricating guides.An...

21 is safeties 169 is battery inside car top box run down or exhausted (This usually happens when main power has been turned off for long periods) 41 ...

New KDL drive comes with a new encoder, all neccessary cables and instruction sheets etc, and only involves a simple change to brake connector wiring....