Elevator Forum

bear in mind that the 1/8" cable stretches all along the length of the cable, not all at one point. This makes the floors off slightly above and below...

Are you in Washington? I've never even gotten an answer as to the format they want. I tried for years to get an MCP program in WA to no avail. We fina...

Do you have power at OD 21/21? If not, pico fuse or output module. If yes, open coil on CD, or mechanically stuck?

Got prints??? From A2 thru BR 7-1 thru Gen Shunt field to A1. This kills the shunt field

Suicide circuit open Replace BR relay and possibility BRT timer

Thanks Turbo6

How much is it overshooting? both directions?? Stopping sequence ISL, LU or LD, 2LR RTT(not dropping) RE 14 & 15 contactors working (core pin not ...

Go to warnerelectric.com

This is for a two speed motor. If you were doing a mod, you would just ignore the low speed motor and use the High speed motor with a drive. I don't t...

Which PMI boards do you have 16modules or 48 modules?

When was it installed? There are several different models of LEV

R6 resistor parallel to the shunt field could be open. This resistor is there to slow response. If it opens, the shunt field equivalence goes up and d...

That was a first thought, but the print doesnt show any orange drop caps. I've worked for Dover distributors for 30 years and never saw one without th...

If the door opeerator circuit (line 329-339) is correct, there is a front and a rear door. Is this the case? OD will drop after the doors open and hit...