Elevator Forum

So I didn’t mix it. I filled it with the AW46. It’s submersible pump and motor on a 3 stage telescopic cantilever. Now I can’t get rid of a bad shakin...

Install maybe

Thank EE. This works great. Do you use the microphone part ?

I have had FCU 47 problems in the past also. I only use Janus now. But ordering from Janus can be annoying recently.. fcu I can buy same day at 2 diff...

You may need to Update your software I believe some older versions of the software have this low pressure problem but only during a jack resync. Do a ...

I have a 3 stage telescopic cantilever that had very hard starts , rough ride , and was leaking. I’m changing seals and oil. And was going to add an a...

Yes. They are the worst. Elevator guy 128 Which oil additive did you use. Is Adams soft stop good additive ? It says 1q/50 gal. Seems like very little...

Brand new TV1 board. Waited 3 months for it on back order .. I guess I’m going to order another one. I dunno what else to do. Wiring looks fine

The manufacturer is actually canton. They finally found a drawing. There’s no sync valves in the drawing so I hope there isn’t any... it’s a cantileve...