Elevator Forum

I have seen that on an AT-400 Linear operator with stripped coggs on the belt.

You have to switch HCIE at the fixture.

If none of the ice cube relays are picking, make sure you have 24vdc at DC6 through the F6 fuse. That 24v regulator on the board is a weak point. If i...

When you say doors are dead, do DO and DC pick but doors don't move? You are only going to read voltage on 20CI-6 if DO and AUD are both picked. And a...

Can you hear me now?

It does look like Elevator Systems but I've never seen a Hydro before.

Maybe KY10 is the new universal board with the 9 pin, I don't remember. So the 3 cars in the group don't have the same generic? Ya, just upgrade the b...

Good questions... I'm not sure I know the answer but I am not aware of any limitations on upgrading generic software on any 188E. I am almost positive...

No I get it. That probably is the best way to handle it. I just thought while I was commenting on what I thought was going on I should share what I, p...

Sounds like the brushes are hanging up in the holders or don't have any spring tension, like it works until the brushes wear away but they are not get...

I would guess Door Watchdog Front but can't find it anywhere. Where are you seeing this?

Looks like it wasn't until V4R1 that the timed resync interval was introduced.

Ya, oldest versions did not have the re-sync interval O30 if I remember correctly.O29 is the lowering time 30 sec. is max so I usually set it to that ...

You must have a minimum of 8-1/2" of dovetail with 6" runby and 2-1/2" stroke buffers. These numbers are critical for the system to be able to correct...

Sounds like they're working surprisingly well for having different software.