Elevator Forum

Did you get the sub code?

Not sure if the Smartrise inputs are active high or active low but if they’re active low and common to your limits it ground, that is exactly what you...

I do have an OMU, came with the GECB. It’s a blue one though (H21) all I had info on was the H1 & H2 (2mb & 4mb). The blue OMU worked with the...

Ya, did that. Got rid of all the parameter errors, now down to a SDK DIO error and a SDK SIO error an I get no CAN0 LED flashing when door type in DCS...

We had an old Dover like that too. You could clean the piston and it would be fine for a week or so. This car ran really hot and we did end up replaci...

I think if you need individual car call security control you have to add a UIO and maybe software. But if you can lock all secured floors with a singl...

What mode is the elevator in when at the floor with the doors open? Menu 4-1

If you do an FLTN, when is the fault happening? How fast is it going, up or down, etc. What kind of drive and what kind of machine?

I had an HMC-1000 doing something similar. Directional limit was right at floor level. You’d get to the floor fine, doors open, close, then MLT. Might...

Something really not right there… Have you re-loaded in IMS for this car? Sounds like you’re looking at the last car you worked on’s IO map.

I know of no way to use anything but a DMC door board. I’ve seen one put inside a new MOVFR operator but, in my opinion, that’s not any better than re...

PS1 is the one to focus on. Measure at the DSP card, adjust to 5.2vdc and check for ripple. Also could be card edge connections. Remove the first 3 bo...

Feel like I saw this with a bad inspection switch on the car top but I’d have to look into that to refresh memory

I’ve used their boards on old ECI operators. I like them.