Elevator Forum

It won’t be on the job stick. I’ve never seen a door board come out without any generic software in it. What has to be loaded is a profile. The easies...

Next time it happens I’d see what it takes to get it running without reloading the job. If it has NV RAM errors try a GET command. That will also tell...

LBY=1 <ENTER>LER=1 <ENTER>BITS0,6 <ENTER>WRT <ENTER>

Ya, LBY sets lobby floor and LER is the # of elevators requested to lobby. Set to 2 for a duplex if you want them both to park there. Last edited ...

That’s interesting, I’ve never heard that before.Set LBY to the bottom floor and LER to 1. And CSW-6 has to be set, BITS0,6 <ENTER>

Have you tried draining the capacitor on the GCIO?

Pretty sure your lights are blinking correctly. I don’t think CAN1 is used on a hydro.

It won’t save unless the controller sees the close limit. There are 2 ways the door board can see limits, ELI = 0 uses the Hall effect sensors on the ...

You can wire a run bug into just about anything. Just wire it into the controller like it’s car top inspection with the safety circuit through the run...

They may always have a 2064 when wired discretely. Sounds like it isn’t seeing the open limit, does it ring out? And do you see the DOL LED on the UIT...

Not to do that, the LON IOs can be deleted in LON Explorer

You have a Smartrise controller with a TK Smartech II door operator and it’s not discrete wired?

On most Tac20s the BPs go back through LON. They started to change it on the newest ones because it was a problem. The best solution is to get them ou...

Well here’s what’s inside the suppressor... It’s a 120 ohm, 1/2 watt (I think) resistor in series with a 1uf snubber capacitor. I believe the part num...