Elevator Forum

Ya, replace one at a time then press it.

Did MCE already have you upgrade the serial cable to the iBox?

And the 1000 uses a real POS power supply

The program will be called PCD. If you have one of those laptops with a bit of everything on it you probably have it. The problem is those programs ar...

The other reason the 289 can’t me my go to meter is the battery life is horrendous. Even using Ultimate Lithium batteries you can’t trend over a weeke...

To park at 1: row 1 of the Personality board, position 3 on, 4 off.0 is the far right. You definitely need a PCD to troubleshoot these. What fault it’...

The 1733 is UPS disconnected and the 1731 is internal UPS fault.

I keep a 289 in the van, super useful when I need it but I’m too impatient to wait for that thing to boot up every time I want to take a measurement. ...

Jump X17-10 to X17-11 to make RPHTL high for the rear and X16-10 to X16-11 for the rear. The Mini Max connectors are just connected to power, ground, ...

So the files in IMS are not the same as the ones that you load through Hyperterminal. And I do have some stuff that I’m not going to share on making h...

They’re in the installation of IMS. If you go to door Smart Fast then Transfer, click upload, then Default, then browse to the IMS folder (C:/programf...

There aren’t different parameters but there are different acceptable ranges of some parameters. Those 2 boards aren’t technically compatible, PA3 and ...

Try eBay

Different UIT all together. The ones for the controllers are fingerprinted to the job file but the 6300HL1 used on the doors and 10K drive is just a d...

That’s a problem with your install of IMS, I’ve seen it before. You can plug a UIT into any PA board and adjust it. I really suggest you order one 630...