Elevator Forum

6300HL1 part number from Thyssen Component Source and I can find the part number for the 6" ribbon cable if you want

the controller doesn't monitor the auxiliary contacts, they just electrically interlock the 2 contactors and the other one on Y starts the BB timer. I...

There are several bulletins and re-wires on this issue, the flickering relay rings a bell. The plug in suppressor on MUTS should be replaced with the ...

The profile doesn't always go through cleanly through IMS, supposed to use Hyperterminal. If you don't have the generic, it's worth throwing it in and...

Just in case anyone looks at this post in the future, the software fix applies to the AC drives only. You can get it from Kone or Cetek, they call it ...

I should add on this subject since the original question mentioned TAC 20. If you continue to get intermittent BP related selector faults despite chec...

I know that the static sensors I/Os can be deleted, I have been told to do so by the factory, they said it doesn't need them on a 3 stop. I'm sure the...

That should have the big black plastic, analog encoder. I have seen the little digital encoder on these when we pick up new jobs. I think they are 500...

Can you see the door parameters with the fast tool? Are you using the same part number board that came out, if not, what was in it and what are you pu...

No Sh*t! I was told the chip was not "bad" just glitches or something and could be burned as a backup after the new chips were in and adjusted. That's...

Just battled that same problem. Are you saying you swapped with another car and then both cars worked??? I replaced them, that would have saved me a d...

Not an expert on these but they are known to lose parameters with power issues. Our tech support suggests archiving the EEPROM or recording all parame...

PM me if you still need it

2nd the Cam Scanner app. If you want a usable copy quick it works pretty great, you can crop it and play with the color options for best results. I us...

I believe the FX board is for AC motors, DMCs use several different door boards and PY4 boards will not work in place of a PY2 with older CLC Software