Elevator Forum

Does this only happen empty car? If so, It’s probably happening on the other floors also. I’ve had this before. Check CFC field circuit.

Since you said it was just moded, and it’s on the brake drop, has the brake been tore down and pm’ed? The Error also has a time factor that your brake...

The picture is a Westinghouse relay logic 4 landing hydraulic control. You should see a metal tag with a GO#. That is the number you will need to obta...

What kind of drive? Or, is this a 2-speed AC motor with high speed windings bad?

Just a question. In the State that I’m in, if you place an elevator back in service that has been decommissioned. The State will require it to comply ...

ANSI code requires that testing procedures and wiring drawings are required to be accessible to the technician. Have the superintendent or sales conta...

Side question: Has anybody on the forum seen or did a geared to gearless, basement or side mount o/h application?Thanks

ASME.org has a full listing of all code books, both hard copy and PDF

If you still have the blue shrader relays, I'd replace them. Replace the MUTS relay also. What are the errors on IMS?

The only packing that work are the ones from the jack manufacture DL Martin. They last twice as long. Adams was sending out Gorman for a while.

Low pressure on a T32 shouldn't stop the up direction out of the pit. Maybe have to reset an error through IMS? What are your errors?

Looks like Peele. They have a online catalog with pictures for reference.

When you have a Westinghouse that uses SA1 & 2, it starts with NA-NB

No need to access the cartop. Your CRIPNA board in the controller, also has the inspection (hand) controls.

Adams A103C1