Elevator Forum

Im assuming this car is a mono space with a v3f25? Since you have brake modules you should be kicking out some kinda error is the adon board tripping ...

You have to break traction after setting the Safeties part of load test its possible but you have to adjust load weighing to do so cheating the car to...

Check your load weighing when the car is at bottom floor throwing the 108 ErrorWith how bad the rails are put in we've had them wedge in the rails whe...

Did the rubber stops fall out of the jam letting the door go to deep into interlock? With eci locks its a problem not sure with gal though.

Yeah sounds like load weighing to me aswell now .. Before with the 197/198 usually the rubber breaks off of the govenor encoder or motor tach wheel we...

A little tape works wonders it there's no adjustment on it

I forgot this gets the board able to communicate with hyper terminal then you have to send the dat file and the five other job parameter files

I was able to "wake" the cpu up putting the car in zmodem mode by Holding rst and udl at the same time then Letting go of rst then udl and the stat li...

Part#us 63099005 is a 5000 ppr ,12 volt supply replaces us62675005Use kone spares parts view that's how I've been cross referencing there parts it's w...

I will definitely go through them and make sure there working

If its a resolve controller it's a bad cob board in cop , you can try to Lon download 5-7-1, sometimes doing it a few times will bring back the board ...

Im having a similar problem Did the whole software thing as well , and still having issues have some parts on order just waiting to go back aswell. Th...